🚀 Lifetime Access launches soon. Create a free account to grab free models now.
← All guides

Print setup · 7 min read

Infill, walls and layer height explained: the slicer settings that matter

What infill percentage to use, why walls make parts stronger than infill, how layer height trades detail for time, and simple presets for decor, everyday and functional prints.

Slicers have hundreds of settings, but a handful decide almost everything about strength, looks and print time. Learn these and you can ignore the rest. For supports specifically, see Supports and orientation.

Walls (perimeters): the real strength setting

Walls are the outlines printed around every layer. Most of a part's strength comes from them, not from the infill inside.

  • 2 walls: decor, figurines, vases
  • 3 walls: everyday items (the usual default)
  • 4 to 6 walls: hooks, brackets, clips, anything that carries load

Adding one wall usually makes a part noticeably stronger for less extra time and filament than doubling the infill.

Infill: how much and which pattern

Infill fills the inside of the part.

Use Infill Pattern
Decor, models, toys 5 to 15% Gyroid or grid
Everyday items 15 to 20% Gyroid
Functional and load-bearing 25 to 50% Gyroid, cubic or adaptive cubic
Flexible TPU parts 0 to 30% Gyroid (controls softness)

Going above about 25% mostly adds time and plastic. If a part needs to be stronger, add walls first.

Gyroid is a great all-rounder: strong in every direction and quiet for the printer. Lightning infill only supports top surfaces, so it is the fastest choice for display pieces that will never carry weight.

Top and bottom layers

Too few top layers leave gaps or "pillowing" on flat tops. Aim for at least 0.8 mm of solid top skin (for example, 4 layers at 0.2 mm or 6 at 0.12 mm).

Layer height: detail vs. time

  • 0.28 mm: fast drafts, large functional parts
  • 0.20 mm: the standard balance for most prints
  • 0.12 to 0.16 mm: figurines, miniatures, lettering, smooth curves

Halving the layer height roughly doubles the print time. A smaller layer height does not make parts stronger; walls and orientation do.

Orientation beats every setting

Layers bond less strongly to each other than plastic does along a line. A hook printed standing up can snap along a layer; the same hook printed lying flat is many times stronger. Orient parts so the force runs along the layers, not across them.

Three presets to remember

Preset Walls Infill Layer height
Decor and display 2 10% gyroid or lightning 0.16 to 0.2 mm
Everyday 3 15 to 20% gyroid 0.2 mm
Functional 4 to 5 30 to 40% gyroid or cubic 0.2 to 0.28 mm

Keep notes

Write down the filament, temperature, speed and settings when a print comes out well. It turns your next success from luck into routine.

Next: How to fix stringing, warping and other common problems and How to print TPU.

Want models that are already set up for your printer?

Every Trove3D file ships with a tested 3MF profile. Start with three free ones.

Get the Free Starter Pack