🚀 Lifetime Access launches soon. Create a free account to grab free models now.
← All guides

Ideas · 6 min read

How to 3D print replacement parts: knobs, clips, handles and battery covers

Measure a broken part, pick the right filament, and know which repairs are safe to print. A practical guide to the most useful thing a home printer does.

Ask printer owners what their most useful print was and the answer is usually a repair: a broken knob, a snapped clip, a lost battery cover or a drawer pull. A replacement knob can cost a few cents of filament instead of a $15 to $30 manufacturer part.

Step 1: search before you design

Someone has probably already made it. Search for the exact model number plus "knob" or "clip" on the big model sites. Our Workshop category has generic knobs, drawer pulls and clips you can scale.

Step 2: measure carefully

You only need a set of digital calipers (about $15 to $25).

  • Measure the shaft diameter and the flat on D-shaped shafts. A 0.2 mm error is the difference between a snug fit and a wobbly knob.
  • Measure hole spacing center to center for handles and pulls.
  • Photograph the broken part next to a ruler before you throw it away.

Step 3: print a fit test first

Print just the part that matters (the hole of a knob, the clip of a cover) at full size. It takes minutes and saves a failed one-hour print. Holes usually print 0.1 to 0.3 mm smaller than designed, so add a little clearance.

Step 4: pick the right material

Part Good material Why
Indoor knobs, drawer pulls, battery covers PLA or PETG Easy to print, strong enough
Clips that flex PETG Bends without snapping
Parts near heat (appliances, cars in summer) ASA, ABS or PETG PLA softens around 55 to 60 °C
Outdoor parts ASA or PETG UV and weather resistant
Grips, bumpers, feet TPU Rubbery and soft

A parked car can get far hotter than PLA can handle. Use PETG or ASA for anything that lives in a car.

Step 5: print for strength

  • Orientation matters more than infill. Layers are weakest when pulled apart, so orient the part so the stress runs along the layers.
  • Use 4 walls and 30 to 50% infill for functional parts.
  • For clips and hooks, print a few and test them before installing.

What not to print

Printed parts are great for convenience, not for safety-critical jobs. Do not print replacements for:

  • Gas valves, burner controls or anything on a stove where failure could affect gas flow, heating or shut-off
  • Car safety parts: brakes, seat belts, steering, airbag covers
  • Load-bearing parts for ladders, child car seats, climbing or lifting
  • Electrical parts that hold live connections

When in doubt, buy the original part.

Free files to start with

  • Parametric potentiometer and appliance-style knobs you can resize
  • Drawer pulls and blind knobs
  • Thumb knobs for hex screws and nuts
  • Cable clips and bag clips

Find them in Workshop and Home & Organization, and read How to fix stringing, warping and other common problems if your first attempt does not come out clean.

Want models that are already set up for your printer?

Every Trove3D file ships with a tested 3MF profile. Start with three free ones.

Get the Free Starter Pack