🚀 Lifetime Access launches soon. Create a free account to grab free models now.
← All guides

Ideas · 6 min read

3D prints for the car, camping and travel (and which filament survives)

Cup holder inserts, visor clips, tent pegs, carabiners, paracord jigs, toothbrush holders and more, plus why PLA should never live in a hot car.

A printer earns its keep on the road. Small clips, holders and organizers fix the annoyances every car, tent and suitcase has. Before you print, though, one rule matters more than any model choice.

Rule one: pick a filament that can take the heat

A parked car in a U.S. summer can reach well over 60 °C (140 °F) inside, and a dashboard in direct sun gets hotter still. PLA softens around 55 to 60 °C and will sag or warp.

Where it lives Use
Inside the car (dash, visor, cup holders) ASA or ABS, or PETG out of direct sun
Outdoors and camping PETG or ASA (UV and weather resistant)
Suitcase, home, garage PLA is fine
Grips, bumpers, anything rubbery TPU

For the car

  • Cup holder inserts and spacers so cans and bottles stop rattling
  • Sun visor clips for sunglasses, cards or a garage remote
  • Cable clips for a dashcam or phone charger
  • Trunk organizers and hooks for grocery bags

Never print car parts that affect safety: brakes, steering, seat belts, airbags or child seats. See How to print replacement parts for what is safe to print.

For camping and backpacking

  • Tent pegs, including ultralight and hard-ground styles (PETG, and carry a few metal spares)
  • Carabiners for gear loops and water bottles: printed carabiners are for light loads only, never for climbing or anything that holds a person
  • Paracord bracelet jigs and spools
  • Emergency whistles, which are loud, light and great for kids' packs
  • A tick remover for hikers, campers and dogs

For travel

  • Toothbrush holders and caps
  • Cable wraps and winders for chargers and earbuds
  • Luggage and bag tags
  • Travel games like a pocket tic-tac-toe

For the garage

  • Paper towel holders under a shelf or on a wall
  • Key hangers by the door
  • Screwdriver and bit holders for pegboard or French cleats
  • Battery dispensers for AA and AAA batteries

Print tips for outdoor parts

  • Use 4 walls and 30 to 40% infill for anything that clips, hooks or carries weight.
  • Print tent pegs and stakes lying flat so the layers run along the length.
  • Test before you trust: pull hard on a clip or carabiner at home before relying on it on a trail.

Browse the Workshop and Home & Organization categories for all of these, and read PLA vs PETG to choose a filament.

Want models that are already set up for your printer?

Every Trove3D file ships with a tested 3MF profile. Start with three free ones.

Get the Free Starter Pack