🚀 Lifetime Access launches soon. Create a free account to grab free models now.
← All guides

Printing tips · 5 min read

How to print articulated and print-in-place toys that actually move

Slicer settings, first-layer tips and troubleshooting for flexi animals, fidgets and print-in-place toys with hinges, so the joints come off the bed free.

Flexi dragons, wiggly octopuses and print-in-place fidgets are some of the most searched 3D prints in the U.S., and the most popular items at craft fairs. They are also the most common source of "it came off the bed as one solid lump" frustration. Here is how to get joints that move every time.

How print-in-place joints work

The designer leaves a tiny gap, usually 0.2 to 0.4 mm, between the moving parts. As long as your printer does not bridge or squish plastic into that gap, the parts stay separate. Almost every failed articulated print is caused by one of three things: an over-squished first layer, over-extrusion, or the wrong scale.

The settings that matter

  • Do not scale down. The gaps shrink with the model. A design with 0.3 mm gaps printed at 70% has 0.21 mm gaps, and that often fuses. Scaling up is fine.
  • First layer: slightly higher than usual (0.2 to 0.25 mm), and slow (20 mm/s). An over-squished first layer is the number one cause of fused joints, because the "elephant's foot" fills the gap.
  • Elephant-foot compensation: turn it on (0.1 to 0.2 mm) if your slicer has it.
  • Flow: calibrate it. Even 5% over-extrusion closes small gaps.
  • Layer height: 0.2 mm is the sweet spot for most designs. Very fine layers do not help joints.
  • Supports: off, unless the designer says otherwise. Supports inside joints are almost impossible to remove.
  • Seam: set to "rear" or "aligned" so the seam does not land inside a hinge.

Material

PLA is the standard. Silk PLA looks amazing on dragons but is slightly more prone to stringing in the gaps. PETG tends to fuse joints because it is stickier. Save it for later, once you have dialed in PLA.

Freeing the joints

When the print comes off, flex each segment gently in every direction before you bend it hard. A few small "cracks" are normal: that is the thin first-layer skin between parts breaking free. If one joint is stuck:

  1. Work it back and forth slowly. Do not twist.
  2. Slide a thin blade or a feeler gauge into the gap from the bottom.
  3. If that fails, a few seconds of hot air from a hair dryer softens the bridge. Then flex.

Troubleshooting

Problem Likely cause Fix
Whole toy is one solid piece First layer squished Raise Z-offset slightly, slow first layer
Joints stiff but move Mild over-extrusion Lower flow 3 to 5%
Segments snap when flexed Too brittle or under-extruded Increase wall count, check temperature
Strings inside joints Temperature too high Lower 5 to 10 °C, enable retraction
Joints too loose, segments fall apart Model scaled up a lot Scale up less, or print at 100%

Where to start

Begin with a small, forgiving design before you try a two-hour dragon. A flexi rex or a simple fidget is a great calibration print for articulated toys. Browse Flexi Friends and the Articulated category, and every file in our Open Library comes with its license and credit right on the page.

Want models that are already set up for your printer?

Every Trove3D file ships with a tested 3MF profile. Start with three free ones.

Get the Free Starter Pack