49 models
A clean stand for a standard screwdriver set, a replacement for a cluttered retail box.
A clamp-on rod holder for a boat rail, tightened with a 1/4-inch stainless bolt.
Holds four fishing rods on a garage ceiling or wall.
A two-half spool for 100 feet of paracord or rope.
Clip-on ends that turn a ratchet bar clamp into an adjustable paracord bracelet jig.
A multi-part jig for tying paracord bracelets to the right length.
An easy-print carabiner for keys and light gear. Not for climbing or holding a person.
Turns a 12 mm coach bolt into a screw-in tent peg for hard or rocky ground.
Clip or zip-tie a GPS or regular wristwatch to a 31.8 mm handlebar.
Gets a floor pump off the garage floor. Sized for a 38.5 mm pump shaft.
A replacement clip that holds a car sun visor up. Print in PETG or ASA so it survives a hot car.
A flat insert for cup holders with uneven bottoms, so glasses and cans stop tipping. Scale to fit your car or recliner.
A sturdy replacement drawer pull for pins about 22 mm apart. Scale to match your furniture.
One quick print that tests supports, scale, overhangs, holes, diameters and bridging.
A strip of blunt cones that keeps birds and cats off railings, fences and windowsills without hurting them. Print in TPU or PETG and zip-tie it on.
A keychain hook for pulling door handles and pressing elevator, ATM and card-reader buttons without touching them. Two versions.
A palm-sized handle that holds a standard 1/4-inch hex bit.
A simple spool holder for filament or wire reels.
a freecad 3d model to hold linear tools like screwdriver, filer
Snap-together hose segments plus a vacuum adapter, for dust collection or fume extraction.
A clip-on guide that holds a knife at a steady angle on the sharpening stone.
A tough storage box with hinged lid and snap latches, fully adjustable in size.
Parametric rugged storage box for OpenSCAD, with Gridfinity-compatible variant. Forked from smkent/monoscad.
Just a simple gauge to help set the tension to the same level every time. It was always a guessing game when setting the tension on my extruder. I would get it