96 models
A pegboard hex-bit holder printed in TPU, so bits push in and out easily.
A tray that holds 87 standard 1/4-inch hex screwdriver bits.
A clean stand for a standard screwdriver set, a replacement for a cluttered retail box.
A small gravity dispenser that holds six AA batteries.
A clamp-on rod holder for a boat rail, tightened with a 1/4-inch stainless bolt.
Holds four fishing rods on a garage ceiling or wall.
A Cuban-yo-yo style fishing spool for survival kits and minimalist fishing.
A two-half spool for 100 feet of paracord or rope.
A small pulley for tarps, bear bags and camp rigging with paracord.
A three-piece paracord and mini survival kit that fits inside a standard duct tape roll.
Clip-on ends that turn a ratchet bar clamp into an adjustable paracord bracelet jig.
A multi-part jig for tying paracord bracelets to the right length.
A hiking carabiner with a built-in whistle for water bottles and kids' packs. Light loads only.
An oval snap ring that works as a light-duty carabiner, shower-curtain ring or napkin ring.
An easy-print carabiner for keys and light gear. Not for climbing or holding a person.
Turns a 12 mm coach bolt into a screw-in tent peg for hard or rocky ground.
An ultralight tent peg designed for carbon-fiber filament: about 6 g each at 140 mm.
A strong tent peg with a rounded head that is gentler on stumbling feet. Print in bright PETG.
Clip or zip-tie a GPS or regular wristwatch to a 31.8 mm handlebar.
Gets a floor pump off the garage floor. Sized for a 38.5 mm pump shaft.
A replacement clip that holds a car sun visor up. Print in PETG or ASA so it survives a hot car.
A cup holder with a deep, wide base that keeps a mug or can from tipping on a desk or console.
A flat insert for cup holders with uneven bottoms, so glasses and cans stop tipping. Scale to fit your car or recliner.
A replacement knob for window blinds (3.5 mm screw hole).